PiBot Wiki

0 Introduction

1 Pinout Reference

2 Checklist Before Use

• 2.1 Prepare Tools
• 2.2 Install Module and Power On
• 2.3 Upload Firmware and YAML
• 2.4 Test Wi-Fi and SD Card
• 2.5 Test Probe and Input Signals
• 2.6 Test Motor Signal LEDs
• 2.7 Test C-Connector Signals
• 2.8 Test MOSFET Outputs
• 2.9 Test PWM Output
• 2.10 Test Laser Output
• 2.11 Test 0-10V Output
• 2.12 Check Done

3 Advanced Tests (Optional)

• 3.1 Test RJ12 Port
• 3.2 Test RS485 Output

4 Hardware Connection

• 4.1 Connect Limit Switches
• 4.2 Connect External Stepper Drivers
• 4.3 Connect External Relay
• 4.4 Connect Pendant
• 4.5 Connect I/O Expander
• 4.6 Connect Spindles and Laser

5 Documentation

6 Introduction to Using grblHAL

7 Software Introduction

8 Frequently Asked Questions

Information

• PiBot Store
• Blog

Return to Previous Level